Three Lencarta Smart Flash Lights including covers, three softboxes and various covers including a honeycomb grid filter. One silver reflector and reflector boom stand.Receivers and transmitter along with power packs etc. Table stands & multiple floor stands as pictured. This huge studio lighting kit was bought with every intention of being used but have never managed to make time for it. Tiny amounts of wear and tear having been in storage but all pieces are in full excellent working condition. Adjustment range: 5 stops (full power to 1/32nd power).
Modelling lamp adjustment: Infinite, from off to full power and anywhere between. Modelling lamp dims whilst recycling. Sync socket: Traditional sync socket for use with any radio trigger or PC cable, if required. USB socket: For use with remote control/radio trigger. Slave cell: Switchable on/off, located at top rear of unit.
Accessory fitting: Standard S fit. Stand fitting: Standard 16mm / 5/8th inch fitting. Power adjustment: Via control knob or Wavesync Commander remote control.
Modelling lamp adjustment: Via control panel. Modelling lamp on/off: Via button or remote control. Slave cell: Via button or remote control. Open flash/test: Via button or remote control. Overheat protection in case of fan failure: Yes.Tilt adjustment: Adjustable locking lever. Umbrella fitting: Standard 8mm, with locking fitting. Softboxes are often considered to be the ideal tool for creating soft light, because they combine the soft, diffused light effect of a shoot-through umbrella with the more controlled, directional (but harsher) light of a reflective umbrella. But traditional softboxes do have a major disadvantage, because, when used in the home or when they are transported, they need to be taken apart and reassembled, which can be very time consuming and sometimes difficult. The Lencarta Folding Pro softboxes completely solve this problem because they open just like an ordinary umbrella it takes just a few seconds!
Umbrella softboxes have been available for some time but most of them are incapable of producing soft light because they are designed to work like a reflective umbrella, with the flash head between the softbox and the subject, which forces them to be placed too far away for soft lighting. The Lencarta Folding Pro softboxes work in exactly the same way as conventional softboxes, so they can be placed as close as you wish. This softbox is ideal for use in most home studios, where room size and ceiling height make extra large softboxes unsuitable. By default, it will fit on Lencarta and Bowens flash heads but you can add a different speedring, to fit either.
Each of our Profold Softboxes is made in the same way, with solid steel construction and uses the same top quality wall and diffusion materials For a softbox to perform well, it needs to be deep, so that the light from the flash head can bounce off of the reflective walls properly, and end up with perfectly even light distribution by the time it reaches the diffusers, and the diffusers need to be made of thick material that diffuses the light properly, and this simply doesn't happen with cheap softboxes that have not been expertly designed and specified. There are other important features, found on our ProFold range, too. Both diffusers are highly resistent to yellowing with age.
And they can be wiped clean if needed. The opening mechanism includes a deflector plate, this restricts the light in the centre of the softbox and directs it towards the softbox walls, which creates extremely even and consistent light quality across the entire front diffuser. This deflector completely prevents the hotspots found on other softboxes.
And the deflector does even more than this, because it allows either the inner or outer diffuser, or even both diffusers, to be removed from the softbox without creating a hotspot, and of course this makes the ProFold a much more versatile tool for creative photographers. And good softbox design isn't just about the light that goes forward, it is also about preventing light from escaping from the sides and rear of the softbox, where it is very likely to cause lens flare, reduce the contrast of your shots and spill unwanted light onto reflective surfaces such as the ceiling and walls.
So, our Profold Softbox range has extra thick walls and, as the photo on the right shows, also has heavy duty fastening flaps at the rear to stop light leakage. And the front diffuser is deeply recessed, this allows a honeycomb grid to be fitted if required and because the recessed area is covered in hook and loop material. What's in the box? The item "Studio Lighting Set Lights Stands Softboxes Lencarta Never used" is in sale since Saturday, June 27, 2020. This item is in the category "Cameras & Photography\Lighting & Studio\Continuous Lighting\Lighting Kits".
The seller is "laurencrowson2" and is located in York. This item can be shipped to United Kingdom, Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Australia, United States, Bahrain, Canada, Brazil, Japan, New Zealand, China, Israel, Hong Kong, Norway, Indonesia, Malaysia, Mexico, Singapore, South Korea, Switzerland, Taiwan, Thailand, Bangladesh, Bermuda, Bolivia, Barbados, Brunei darussalam, Cayman islands, Ecuador, Egypt, Guernsey, Gibraltar, Guadeloupe, French guiana, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Sri lanka, Macao, Monaco, Maldives, Martinique, Nicaragua, Oman, Pakistan, Peru, Paraguay, Reunion, Saudi arabia, South africa, United arab emirates, Ukraine, Chile, Bahamas, Colombia, Costa rica, Guatemala, Honduras, Jamaica, Kuwait, Panama, Qatar, Trinidad and tobago, Uruguay, Viet nam.